working...

Well today got up early and started to move here and there. Went to get some groceries and then sat down to start modeling. In order to get the scaling correctly i had to do some digging in the cryengine forums and then finally things were in place and started.


The first model i am doing is the santhome community centre. I decided that i will do the high poly mesh and give the high poly work to sanjay. So that i have things to work in the game and he can slowly make the high poly mesh.

Santhome Community Service Centre - Santhome

The measurements in terms of lengths were taken from the maps and the scale. So i will get roughly 90% of the scale right. I am seriously less in the amount of references i have so it was difficult to model some things that were inside.


I first created the proxy mesh which is the size of the entire building. But i dont think a physics proxy is needed as there will be no collision with the building via the car. So most probably the proxy will be deleted. There are a lot of unwanted poly's sanjay will have to clean up the mesh after he gets it.

Left to right- Proxy, low poly, high poly

I have put the meshes in different layers so that sanjay can work faster. It already looks high poly but cryengine can do it.

Sanjay informed that there are some changes in the internship game we were doing. So need to work on that. Not feeling too good now, my nose is running, maybe its from the cold snickers i was eating. I took em from the freezer... It was hard as ROCK!! but my teeth is better :P

Need some rest so will not be working tonight...